PDA

View Full Version : Star Wars Jawa Sandcrawler remote



Star Wars Collector
01-21-2009, 09:19 AM
Im trying to figure out if a sandcrawler remote controler works on all sandcralwers or just the one it came with originally??? Are there any ways to fix sandcrawlers if they dont operate whether its the controller or the vehicle itself? How many stickers are supposed to be on it? Does one go on the inside of the elevator?

LusiferSam
01-21-2009, 08:32 PM
Im trying to figure out if a sandcrawler remote controler works on all sandcralwers or just the one it came with originally??? Are there any ways to fix sandcrawlers if they dont operate whether its the controller or the vehicle itself? How many stickers are supposed to be on it? Does one go on the inside of the elevator?

Ok that's answer one question at a time. As far I as know the remote is independent of vehicle. I had a remote for a Batmobile (made in '90) work on the Sandcrawler. The RC on this is pretty dumb. The motor runs one way until the button on the remote is held, then it runs the other way. Once the signal is gone the motor run the original way again. There's no channels or anything like that.

As for the stickers, try this page (http://www.12back.com/vehicles/crawler.php3) for the moment. It has the instructions, but is very lacking about the stickers. I believe that there is one on the elevator, but no where else outside the cockpit. As for the stickers themselves, you need look no farther than eBay (http://cgi.ebay.com/VINTAGE-STAR-WARS-SANDCRAWLER-STICKER-SHEET_W0QQitemZ370131989497QQcmdZViewItemQQptZLH_D efaultDomain_0?_trksid=p3286.m20.l1116) to see how many.